![fastboot flash recovery failed unknown command fastboot flash recovery failed unknown command](https://alaev.info/wp-content/uploads/2013/03/fastboot-flash-recovery.png)
Some users have had issues with flashing this so i have done some text editing of some of Pauls scripts for his root method to make a similar one click install for Clockwork Mod Recovery. up and power on) and flash the gapps zip file you just downloaded and then do a wipe/factory reset - this will make sure you get the full google setup on next boot. Then boot in to recovery (power off, pull battery and replace, then hold vol. To do this download the following file ( ) and copy it to your SDCard (be sure that you copy it to the SDcard and NOT the internal 2gb). Now might be a good time to download and install Gapps. Which link you go to is your choice.Īfter you have followed all the steps above you will have the new ICS B926 and CWM installed. Once this is done, follow the instructions to install clockworkmod recovery from either ( ) or ( ).
![fastboot flash recovery failed unknown command fastboot flash recovery failed unknown command](https://community.e.foundation/uploads/default/original/2X/0/0ac657964ae8209bae6122ec195c4b63efa2a302.png)
down and power to go in to fastboot - the phone will hang on the splash screen whilst in fastboot. Power off your phone, remove battery for a few seconds and replace, then power on whilst holding vol.Run 'unlockbootloader.exe' again and this time click 'Unlock BOOTLOADER' - you should see the capacitive buttons flash on your phone and the app will close on completion.Run 'unlockbootloader.exe' and click 'ROOT Your Phone' - a console will appear and then close, after this open the app drawer and check that Superuser.apk has been installed OK, if so, you now have root.At this point it is wise to remove the dload folder from the sdcard so you do not mistakenly re-flash the update (thanks to tronads for pointing this part out).Boot in to freshly installed ICS, install ADB drivers from the ISO mounted on the phone, enable USB debugging and then connect USB cable - make sure adb works.